Carter Jardine.

Designed a Raspberry Pi 5 add-on board with an LM706x0-based 5V 5A regulator and a Nordic nRF52840 module for wireless communication and analog sensing. The 6-layer prototype board was sent to China for manufacturing and assembly.

Schematic capture and PCB layout for a hall effect sensor board. Analog inputs are captured on a nRF52840 (bottom) and transmitted wirelessly and through an RJ45 connector utilizing a SP3485EN IC. Visual information is displayed on the OLED screen. Fabricated and assembled in China.

Co-developed an analog heart rate monitor at UBC with visual output display. Responsible for schematic capture, PCB layout, and hand soldering — delivering a clean, functional board within tight academic timelines.

A micro-sized brushless motor I designed and 3D printed for a university project. The motor was wound with thin copper wire and worked when connected to an electronic speed controller. Due to plastic heat restrictions the motor lifespan was short.

PCB designed around an Arduino Nano that can turn off any common TV by brute-forcing infrared power codes. Code adapted from Adafruit's device that used an ATTiny85. First PCB iteration worked perfectly.

Designed a PCB for the LM380 amplifier for a high school electronics class. Successfully amplified both channels of an audio signal.

Worked with a UBC research team (HCI Lab) to develop a drone capable of spinning its outer shell to display video through the persistence-of-vision effect. Designed, sourced, programmed, and flew the drone while also contributing to other research projects.

Built multiple FPV racing drones and competed provincially, qualifying for nationals. High-pressure race environments sharpened skills in rapid electronics diagnosis, repair, and tuning — where any mistake means getting a DNF.

Worked within a UBC Capstone team to design a relay VTOL drone for North Shore Rescue in Vancouver. The aircraft acts as a communications bridge to extend the operational range of DJI drones used by search-and-rescue operators in challenging terrain.

Operated a local drone repair business supported by a large Facebook community. Repaired a wide range of consumer and commercial drones, building a strong local reputation and deep familiarity with modern manufacturing approaches used by major brands.

Led electronics selection, wiring, programming, and flight operations on several large-scale UAV platforms with propellers up to 28". Responsible for the full build pipeline from component spec to maiden flight.

This is a 15Ah 12s lithium battery that I designed, assembled, and tested for a heavy lift drone. It was designed to be charged as two 6s batteries and is capable of high current outputs. The battery has an impressive 238 Wh/kg energy density.

This battery is designed to be friction mounted on a pole. It features a 6s3p configuration with a built-in high-current switch and voltage monitor.

Prototyped, sourced, and assembled the electrical systems for the initial production run of Templar Marine's electric boat line. Extensive testing and iterative troubleshooting were required to meet strict performance specifications.